Remington HC5900 Handbuch Seite 8

ENGLISH
, STEP 5 – The finishing touches
• Use the clipper without an attachment comb for close trimming around the
base and sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper.
• Place the reversed clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
, AUTO TURBO SYSTEM
• Push the power button and the appliance runs in Normal Mode. The Auto
Turbo will automatically activate when the clipper senses it needs more
power.
• To run in Turbo mode, hold down the power button for 2 seconds and the
clipper will run in boost until it is turned off.
C CARE FOR YOUR HAIRCLIPPER
• Your clipper is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
• Always keep the attachment guide comb on the trimmer blade.
, AFTER EACH USE
• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Brush the accumulated hair from the blades and body of the clipper.
• To clean unit, wipe with a damp cloth and dry immediately.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off
excess oil.
, WASHABLE BLADE CLEANING
, This clipper is fully washable and therefore can be rinsed under a running
tap. However, avoid getting the micro USB port wet.
• To remove the blades ensure the unit is off. Press the blade release button
on the back of the clipper when it meets the blade and push away from the
clipper.
• To reattach once the blades are cleaned and dry, align the bottom of the
blade with the bottom blade housing tab and slide the cartridge back into
place until you hear a click.
• Do not run the entire unit under the tap, only the blade set is meant to be
submerged in water.
8