BOMANN DU 622.1 Bedienungsanleitung, Garantie Seite 19

Assembly Assembly Assembly Assembly
WARNING: WARNING:
WARNING: WARNING:
• When assembling or inserting the
be connected to the mains.
• Failure to use the mounting fixtures may lead to a Failure to use the mounting fixtures may lead to a risk of electric shock
CAUTION CAUTION: : : :
CAUTION CAUTION
• Before mounting, check that the wall check that the wall or wall unit has sufficient load capacity to bear
• When drilling the holes in the wall always make sure that no existing electrical cables or other objects are When drilling the holes in the wall always make sure that no existing electrical cables or other objects are When drilling the holes in the wall always make sure that no existing electrical cables or other objects are
damaged.
• Make sure that the vents are clear of obstacles and are not covered. Make sure that the vents are clear of obstacles and are not covered.
NOTE: : : : Recomm NOTE Recommendations for preparation work endations for preparation work endations for preparation work endations for preparation work
NOTE NOTE Recomm Recomm endations for preparation work endations for preparation work endations for preparation work endations for preparation work
• When installing, ask another person
• Wear protective gloves to prevent injuries from any sharp edges. Wear protective gloves to prevent injuries from any sharp edges.
1 1 1 1
Mounting at the wall
• The hood is mounted at the wall or
centrally above the hob in conformance
• Remove the grease filter grid or aluminum grease filter (depending on the model). Remove the grease filter grid or aluminum grease filter (depending on the model).
• Select the fume outlet and set the lever to the appropriate position, see "Selecting the fume outlet".
Mounting at the wall Mounting at the wall Mounting at the wall Mounting at the wall
• Mark the necessary holes for the wall mounting by using the supplied drill template and check them with a necessary holes for the wall mounting by using the supplied drill template and check them with a necessary holes for the wall mounting by using the supplied drill template and check them with a
spirit level.
• Drill two mounting holes Ø 8 mm into the wall and insert the dowel pins (1). Then rotate the mounting mounting holes Ø 8 mm into the wall and insert the dowel pins (1). Then rotate the mounting mounting holes Ø 8 mm into the wall and insert the dowel pins (1). Then rotate the mounting
screws (2) as far as these stick out about 4 mm from the wall. screws (2) as far as these stick out about 4 mm from the wall.
• Suspend the hood and tighten the screws through the hood body. Check the secure fitting and Suspend the hood and tighten the screws through the hood body. Check the secure fitting and horizontally Suspend the hood and tighten the screws through the hood body. Check the secure fitting and
position.
Mounting below the wall u Mounting below the wall u Mounting below the wall u Mounting below the wall unit
• Hold the hood to the specified cabinet position and draw the drilling points from the inside of the unit corr to the specified cabinet position and draw the drilling points from the inside of the unit corr to the specified cabinet position and draw the drilling points from the inside of the unit corre-
sponding to the four screw holes. Check them with a spirit level. sponding to the four screw holes. Check them with a spirit level.
the extraction filter as well as the carbon filter mat
person to assist.
2 2 2 2 3 3 3 3
at the wall or below a suitable wall unit. Determine the position
conformance with the specified safety distances.
the lever to the appropriate position, see "Selecting the fume outlet". the lever to the appropriate position, see "Selecting the fume outlet".
nit nit nit
risk of electric shock.
risk of electric shock risk of electric shock
4 4 4 4
Mounting below the wall unit
19
mat, the appliance must not
bear the extractor hood.
5 5 5 5 6 6 6 6
position of the extractor hood