Manual Pairing; Operation; A) Turn On And Standby Mode - Renkforce RF-TB240WW Bedienungsanleitung

b) Manual pairing
• Make sure that the soundbar and the subwoofer are connected to the mains grid and the soundbar is in standby
mode. The standby indicator (1) is lit red.
• Hold the PAIR (16) button until the subwoofer switches to manual pairing mode and the pairing indicator lamp (17)
flashes quickly.
Press the PAIR button within 20 seconds. The subwoofer exits manual pairing mode after 20 seconds. If
this happens, unplug the subwoofer from the mains for approx. 3 minutes and repeat the steps for manual
pairing.
• Switch on the soundbar with the on/off button
• The pairing indicator lamp remains lit once pairing is complete and the connection is established.
• If the pairing indicator lamp continues flashing, pairing was not successful. If this happens, unplug the subwoofer
from the mains for approx. 3 minutes and repeat the above steps for manual pairing.
If problems occur during pairing, please refer to the following notes and tips:
• Determine if a conflict exists in coupling or a strong interference with the wireless transmission. The problem may
be caused by other electronic devices. Fix any such errors and restart the pairing process.
• The distance between the subwoofer and the soundbar must not exceed 6 meters in open space.
• If the soundbar and subwoofer are not pared and are turned on, the pairing indicator lamp flashes. In this case, pair
the devices again. Repeat the above steps for manual pairing.

10. Operation

Use the buttons on the device or on the remote control to operate the soundbar. Some functions may be controlled
using the remote control only.

a) Turn on and standby mode

• After connecting to the mains grid, the soundbar switches to standby mode. The standby indicator (1) is lit red.
• Press the on/off button
• Press the on/off button
• If the device detects no signal input for approx. 15 minutes, it automatically switches to standby mode. The standby
indicator lights up red.
• Disconnect the mains cable from the mains outlet to completely disconnect the device from the grid.
(4, 22).
(4, 22) to switch on the device. The LED of the previously selected mode is lit or flashes.
again to switch the device back to standby mode.
37