Ecom Instruments MCAL 4200 Bedienungsanleitung Seite 49

Contents
1. Introduction
1.1 Standard Equipment
1.2 Safety Information
2. Calibrator Interface
2.1 Main Display
2.2 Menu Bar
2.3 Cursor Control / Setpoint Control
3. Using Measure Modes (Lower Display)
3.1 Measuring Volts and Frequency
3.2 Measuring mA
3.3 Measuring Temperature
3.4 Measuring Pressure
4. Using Source Modes (Lower Display)
4.1 Setting 0 % and 100 % Output Parameters
4.2 Using the Automatic Output Functions
4.3 Sourcing mA
4.3-1 HART
4.4 Simulating a Transmitter
4.5 Sourcing Volts
4.6 Sourcing Frequency
4.7 Sourcing a Pulse Train
4.8 Sourcing Thermocouples
4.9 Sourcing Ohms/RTDs
5. Using Isolated Measure Modes (Upper Display)
5.1 Measuring Volts and mA
5.2 Measuring Current with Loop Power
5.2-1 HART
5.3 Measuring Pressure
6. Using the Upper and the Lower Display for Calibration and Testing
6.1 Testing an Input or Indicating Device
6.2 Calibrating an I/P Device
6.3 Calibrating a Transmitter
6.4 Calibrating a Pressure Transmitter
7. Remote Operation
7.1 Setting up the RS-232 Port for Remote Control
7.2 Changing Between Remote and Local Operation
7.3 Using Commands
7.4 Remote Commands and Error Codes
7.5 Entering Commands
8. Specifications
9. Maintenance / Warranty
48
Resistor Selection
TM
Resistor Selection
TM
Page
49
49
49
51
52
54
56
56
56
56
57
58
60
60
60
60
61
62
62
63
63
63
64
66
66
66
67
67
68
68
68
69
70
70
70
71
71
74
78
84
88