Functions - clearaudio electronic double matrix professional SONIC Bedienungsanleitung

User manual / Bedienungsanleitung

5. Functions

5.1 Automatic cleaning
• Automatic / Superclean / Eco mode
The "Auto" button has a multifunction. Pressing it once gives "Automatic mode". Pressing it
twice in quick succession starts the "Superclean mode", indicated by slow flashing of the blue
LED ring that surrounds the button. The third program is the ECO mode. If you hold the
button "Auto" for three seconds, you will start this program (indicated through the fast
flashing ring of the button "Auto").
If the respective cleaning program (Auto mode / Super Clean / ECO mode) is finished, the
blue ring of the button will flash short and constant. You can cancel every automatic mode
by pressing the button "Power" shortly.
5.2 Manual cleaning
• Power
Starts the platter rotating and switches on the sonic cleaning function.
• Liquid
Press to apply cleaning fluid to the upper and lower sides of the record.
• Platter
Press to change the platter's rotational direction.
• Platter Speed
Turn to adjust the platter rotation speed.
• Vacuum
Activates the suction drying process while also stopping the sonic cleaning function.
5.3 Automatic and manual cleaning
• Antistatic brush
The antistatic brush arm is used to discharge any static
that is generated during the drying process.
After completion of the automatic programs or manual
cleaning, the dry record should pass the antistatic brush
at least for 2-3 full rotations. Turn the antistatic arm
above the record to the outer point. The record will start
to turn and the constructed static will derived.
The antistatic function can only be activated with opened
suction arm.
After 2-3 full rotations, turn the antistatic arm back to the start position. The rotation of the record
ends automatically.
• LED level indicator
Shows the level of cleaning fluid currently in the reservoir (0% to 100%).
8
Pic. 3: Turning the antistaic unit
© clearaudio electronic GmbH, 2017/11