Herunterladen Inhalt Inhalt Diese Seite drucken

Introduction; General Information; Intended Use; Waste Management - welltherm HT0606_2011 Bedienungsanleitung

Infrarotheizung
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Bedienungsanleitung Infrarotheizungen Typ HT
Manual for infrared heating elements type HT
GB

2. Introduction

3. General information

4. Intended use

5. Waste management

Dear customer,
Thank you very much for purchasing our product. This infrared heater was developed and
produced carefully. In this manual you will find important information on how to start run-
ning your Welltherm infrared heater. The infrared heater will satisfy you by easy installation,
flexibility in mounting and it is maintenance free. Please read this manual carefully before
you get started for your safety. Hold this manual in reach and don't forward the infrared
heater without this manual!
Thank you for your trust.
The heating element will not work as a conventional convection heater for it uses the inf-
rared heat. When energize the heater for the first time the cold surroundings (ceiling, floor,
furniture, walls) have to be heated up first. If you will not get a pleasant temperature directly
please hold the heater energized until you will get a convenient indoor climate. This process
can last some hours up to some days. When all solid frames are warmed up there will be a
comfortable temperature in the room. With this condition the turn on time of the heater
can be reduced to minimum. For an efficient and effective control of your infrared heater
we recommend the use of our quality wireless thermostates. Please contact us for further
information.
The infrared heating panels are due to be used as wall or ceiling heater (see first side). Please
note that the notice of this manual is part of the intended use. Please don't use the heater
for outdoor purposes. Also the heater is not suitable for rooms where it is exposed to water
and for all applications which are not explicitly named intended use.
The infrared panel and the power outlet must not be mounted in the protection zone 0, 1, 2
of plumbed rooms. The minimum distances to other items and walls are shown in the picture
below!
Please depollute the package material and the device according to its specification. Electri-
cal equipment contents recources as also polluting materials. Therefore it has to be disposed
of as hazardous waste. Follow your regional regulations!

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis