Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungsanleitung Infrarotheizungen Typ HT
Manual for infrared heating elements type HT
GB
9. Installation
Step 2
Hold the template tot he ceiling and adjust it in the suitable direction.
Step 3
Mark the 4 drilling positions (note that only the center holes are relevant!).
Tip: Check if tubes or electrical lines are without the drilling area. Use a metal detector or
similar.
Step 4
Use the suitable drill for drilling the holes.(depth=dowel length). The hole length should meet
the requirements of the dowel. Use a depth stop if necessary.
Tip: Use a vacuum cleaner to avoid dust.
Step 5
Due to the chosen kind of fixation the suitable dowels/roof bolts are plugged in and the
screws/hooks/threaded studs are screwed-in.
When using a steel chain or cable connection an M6 eyebolt has to be used for the connecti-
on between heater and chain/cable On the ceiling side of the chain/cable there has to be used
a suitable dowel solution. Note: These parts are not included in the package!
Step 6
Hang the heater to all 4 connectors. Don't use less than 4 holders!
Important: Although the heater is equipped with a good thermal insulation on the backside
the intended minimum distance to the ceiling has to be confirmed. Elsewhere a hot spot can
appear!
Step 7
Now the heater is ready for use! To optimize the efficiency and the consumption costs oft
he system we recommend the use of wireless thermostates. To simplify the assembly of the
ceiling heaters a separate accessories kit for ceiling assembly is optional available. Don't
hesitate to contact us for further information.
Have a lot of fun with your infrared heater.
Werbung
Inhaltsverzeichnis
