Description
The DC 3800c Turbo is a machine with large suction
capacity and robust construction while still being
compact and easy to maneuver.
It is ideal for spot extraction on most types of hand-
held tools and for industrial cleaning (38 mm and
50 mm system).
Operation
Connect the machine to a suitable power source ac-
cording to the specifi cation plate on the machine. If
the electrical cord on the machine becomes damaged
it should be replaced.
The fi lter should be cleaned 1-2 times per day with
continuous running or if the machine is equipped with
a fi lter monitor, when this is in the red area.
For fi lter cleaning:
1. Start the machine.
2. Disconnect the hose from the suction casing.
3. Place the suction hoses free end over the fi lter
cleaning handle.
4. With slow, even motion open the pulse top by
depressing the handle. Repeat three to
four times.
The fi lter cleaning with reverse pulse gives the fi ne
fi lter extra long life and constant capacity. As well
the fi lter is suitable for a wide range of dusts than
earlier models. The shaker top on the older model
DC 3800c Turbo can be changed out for the new
pulse cleaning top.
5. Reconnect the hose to the suction casing.
6. If the fi lter condition meter reads green work
can continue, if in the red, pulse clean
again. If after several repetitions, the fi lter
condition still shows red the fi ne fi lter 42025
must be changed.
The plastic sack should be changed only after the
fi lter has been cleaned. The sack should be changed
when the dust level is about 5 cm under the foot valve.
The plastic sack should be sealed after removal from
the machine.
Use only original plastic sacks.
DC 3800c Turbo - 9
Art nr 94131