Saving Settings And Writing Them On Other Controls - Geberit HyTronic Service-Handy Betriebsanleitung

HyTronic Service Handy, Bidirectional
Operation
Saving settings and writing them
on other controls
All the settings of a control are saved and written on
another control of the same type (same product).
Prerequisites
• Control is installed correctly and operating
1
Switch on HyTronic Service Handy; the following
information is displayed
GEBERIT
00 Bidirect
08 Unidirect
Settings
2
Aim HyTronic Service Handy at sensor of control
and select the menu item [Bidirect] [Bidirekt] with
the button "OK". HyTronic Service Handy
establishes contact with control.
Point to
Device!!
Menu of the control is displayed
Urinal
00 Ctrl ON
01 Ctrl OFF
02 Commands
3
Press button "ST". The following information is
displayed
0 Memory 0
1 Memory 1
2 Memory 2
3 Memory 3
Four memory locations are available.
4
Go to a memory location, e.g. [Memory1]
[Speicher1] and press "OK". Menu is opened. Go
to [Sto] and press "OK".
0 Memory 0
1 Memory 1
Rcl
2 Memory 2
18
GEBERIT
00 Bidirekt
08 Unidirekt
Einstellung
Auf Sensor
richten!!
Urinal
00 EIN
01 AUS
02 Befehle
0 Speicher 0
1 Speicher 1
2 Speicher 2
3 Speicher 3
0 Speicher 0
1 Speicher 1
Sto 1 Rcl Sto
2 Speicher 2
5
Press "OK". The following information is briefly
displayed
Stored 1
Display goes back to initial position. Settings are
now saved
0 Memory 0
1 Memory 1
2 Memory 2
3 Memory 3
6
Press "Esc". The following information is
displayed
Urinal
00 Ctrl ON
01 Ctrl OFF
02 Commands
7
End contact. Go to menu item [Ctrl OFF] [AUS]
and press "OK" twice
00 Ctrl ON
01 Ctrl OFF
02 Command
03 Program
The following information is displayed:
GEBERIT
00 Bidirect
08 Unidirect
Settings
8
Aim HyTronic Service Handy at sensor of new
control and select the menu item [Bidirect]
[Bidirekt] with the button "OK". HyTronic Service
Handy establishes contact with control.
Point to
Device!!
Menu of the control is displayed
Urinal
00 Ctrl ON
01 Ctrl OFF
02 Commands
Abgelegt 1
0 Speicher 0
1 Speicher 1
2 Speicher 2
3 Speicher 3
Urinal
00 EIN
01 AUS
02 Befehle
00 EIN
01 AUS
02 Befehle
03 Program
GEBERIT
00 Bidirekt
08 Unidirekt
Einstellung
Auf Sensor
richten!!
Urinal
00 EIN
01 AUS
02 Befehle