Falcon toledo FS Gebrauchs- Und Wartungsanleitung Seite 19

LOWER THE FRONT ROLLER until the front of the
appliance starts to rise using the Allen key supplied.
Now LOWER THE TWO REAR ROLLERS so that they
contact the floor, by fitting the levelling tool (or 8mm
socket) on the hexagonal adjusting nut as shown
below and turning clockwise.
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the
front bottom corners of the cooker.
Unfold the rear edge of pack base tray. Carefully
push the appliance backwards into position. Push
the appliance close to its final position, leaving just
enough space to get behind it.
Measure the height of the cabinet the ovens
are lining up with (see diagram below), this will
determine whether the top in fill trim needs to be
fitted. The majority of units will be around 720mm
and will not require the in fill trim, for those between
730 and 735 the trim should be fitted. See diagram.
INSTALLATION
Check the appliance is electrically safe when you have finished.
Fit the side trims to the appliance using the three
screws for each trim that are included. See diagram.
Fit the top in fill trim where needed, lining the front
edge with the front of the side trims at either side.
Adjust the height of the front roller with the Allen
key so that the top of the ovens unit ( with in fill trim
if required ) is just below the height needed to slide
under the worktop and adjust the rear rollers with the
8mm socket or levelling tool until it is roughly level.
19