Unpacking The Appliance; Moving The Appliance - Falcon toledo FS Gebrauchs- Und Wartungsanleitung

Surfaces of furniture and walls at the sides and rear
of the appliance should be heat, splash and steam
resistant. Certain types of vinyl or laminate kitchen
furniture are particularly prone to heat damage and
discolouration. We cannot accept responsibility for
damage caused by normal use of the appliance
to any material that de-laminates or discolours
at temperatures less than 65°C above room
temperature.
A clearance of 130mm is required if the appliance is
built near a corner of the kitchen to allow the oven
doors to open. The actual opening of the doors is
slightly less but this allows for some protection of
your hand as you open the door.

Unpacking the Appliance

Do not remove any packaging from the appliance
until it is directly in front of the place it is to be
installed (unless it will not fit through a door in its
outer packaging).
Cut the banding straps and lift the cardboard box
off, leaving the appliance standing on the base
packaging. See the loose unpacking sheet.

Moving the Appliance

WARninG WHEn THE APPLiAnCE iS REMOVED
FROM THE PACK iT iS FROnT HEAVy AnD CAn TiP
FORWARDS iF DOORS ARE OPEnED ETC. DO nOT
REMOVE THE FROnT ROLLER UnTiL THE APPLiAnCE iS
SECURELy FiXED in POSiTiOn.
The appliance is heavy. Take great care.
We recommend two people manoeuvre the
appliance. Ensure that the floor covering is firmly
fixed, or removed to prevent it being disturbed
when moving the appliance around. You will need
the levelling tool. From the back tilt the appliance
forward and remove the rear half of the polystyrene
base pack.
INSTALLATION
Check the appliance is electrically safe when you have finished.
Repeat from the front and remove the front half of
the poly base. Pull the drawer out to its furthest point.
Push the ends of the plastic clips – down of the left-
hand side, up on the right-hand side – to release the
catches holding the drawer to the side rails. At the
same time pull the drawer forwards and away from
the side rails.
Lower the Rollers.
Fit the Allen key tool to the centre roller lowering
mechanism (C in the fig. below).
A left rear roller, B right rear roller, C centre roller
18