TFA 98.1009 Bedienungsanleitung Seite 30

Note:
If the Projection clock is powered through the adapter, the projection will be constantly ON at the highest
brightness level unless the brightness level is manually changed to a lower brightness level afterwards. And
the brightness of the projection can be change accordingly to enhance the clarity of the projected time by
pressing the button.
If the Projection clock is battery operated, the projection will be ON at the highest brightness level only when
the SNOOZE button is pressed. The intensity of the brightness level of the projection cannot be changed. If
the SNOOZE is released, the projection will be turned OFF.
BATTERIES POWERED WITH THE USE OF AC/DC ADAPTER
If the Projection clock is first powered by batteries and the power adapter is subsequently used for extended
period of time, the main power source of the projection clock will switch to AC/DC power. The batteries will
then act as a backup power source in case of power failure.
TO RESET THE PROJECTION CLOCK
To reset the Projection clock to the factory default setting or in case of a malfunction, please remove all
batteries from the unit and unplug the AC/DC adapter from any power source. Wait at least for 3 minutes
before powering up the Projection clock again.
30