Electrical Safety - Sygonix 1578792 Bedienungsanleitung

b) Electrical safety
• Exercise particular caution in the presence of children. Children do not understand the hazards
associated with the incorrect use of electrical devices. For example, children may attempt to insert
objects in the openings of the product, which can cause a fatal electric shock. There is also a significant
risk of injury and burns due to hot surfaces!
• Never touch or operate the product if your hands are moist or wet. This may result in a fatal electric
shock!
• Completely unwind the mains cable before use. A mains cable that is not completely unwound can lead
to overheating, which constitutes a fire hazard!
• Do not insert any objects into the openings on the product. This may cause a fatal electric shock, or the
objects may damage the product.
• Before connecting the product to the mains, check that your local A/C mains voltage matches the
specifications on the nameplate.
• The heater is constructed according to protection class I. Only use a grounded mains socket (230 V/AC,
50 Hz) connected to the public grid to power the product.
• Never pour any liquids over electrical devices or place objects filled with liquid next to the product. If
liquid or an object does enter the interior of the device, power down the respective socket (e.g. switch off
the circuit breaker), and then remove the mains plug from the mains socket. Discontinue use and take
the product to a specialist repair centre.
• The mains outlet must be located near to the device and be easily accessible.
• Never unplug the mains plug by pulling on the cable. Always use the grips on the plug.
• Unplug the mains plug from the mains socket if you do not plan to use the device for an extended period
of time.
• For safety reasons, unplug the mains plug from the mains socket during thunderstorms.
• Do not touch the mains cable if there are any signs of damage. Power down the respective mains socket
(e.g. via the respective circuit breaker), and then carefully pull the mains plug from the mains socket.
Never use the product if the mains cable is damaged.
• Damaged mains cables must be replaced by the manufacturer, an authorized repair centre or a qualified
electrician.
• Never insert or unplug the mains plug when your hands are wet.
• When setting up the product, make sure that the mains cable is not pinched, kinked or damaged by
sharp edges.
• Avoid excessive thermal stress on the mains cable from extreme heat or cold.
• Do not use an extension cable, power strip or switching device. Only connect the mains plug to a wall-
mounted mains socket. If an extension cable is required, the wire must have a cross section of 1.5 mm²,
and it must be protected with a 10 A fuse.
• Do not wind the cable around the heater.
18