Abus Secvest FUBE50001 Installations- Und Bedienungsanleitung Seite 42

Displays and functions
Teach-in process
1. Set the Secvest to "teach-in mode" (see installation instructions for wireless
alarm system) and send a teach-in signal from the wireless control panel to the
wireless alarm system.
2. The teach-in signal can be sent either by inserting the batteries or by activating
the tamper switch.
3. Once the teach-in signal has been picked up by the wireless alarm system, it
will emit two beeps and the incoming signal strength will be displayed.
4. Confirm the successfully completed teach-in on the control panel.
operation
 If the user code is entered incorrectly three times, the control panel
keypad will flash and will be locked for 5 minutes.
 You can cancel incorrect code entries by pressing the star key
(see adjacent figure).
Installation and start-up
EN 17