HAWA -Concepta 40 Planungs- Und Montageanleitung Seite 6

1 Table of contents
Contents
1 Table of contents
2 Product information
3 Safety instructions
4 Abbreviations, symbols
5 Overviews
6 Planning
7 Calculation
8 Pre-assembly
9 Assembly
10 Disassembling
6
5.1 Overview: Left-hand system
5.2 Overview: Connector 55 (optional)
5.3 Overview: Connector 110 with and without plinth (optional)
5.4 Overview: Two inset pivot sliding doors
5.5 Overview: Position numbers
6.1 Planning: Inset doors
6.2 Planning: Guide for two pivot sliding doors
6.3 Planning: Doors closing against base and top section with Connector 55
6.4 Planning: Doors closing against base and top section with Connector 110
6.5 Planning: Doors in wall recess
7.1 Calculation: Door weight/height ratio
7.2 Calculation: Plan view dimensions
7.3 Calculation: Hardware depth
7.4 Calculation: Drill hole positions
8.1 Pre-assembly: Processing the left-hand profile
8.2 Pre-assembly: Processing the right-hand profile
8.3 Pre-assembly: Doors
8.4 Pre-assembly: Cabinet face
8.5 Pre-assembly: Outside face
8.6 Pre-assembly: Shock absorber
8.7 Pre-assembly: Upright
8.8 Pre-assembly: Aligning the cabinet
9.1 Assembly: Scissor and upright, left-hand system
9.2 Assembly: Scissor and upright, right-hand system
9.3 Assembly: Doors
9.4 Assembly: Door closing system
9.5 Assembly: Fine adjustment of door upright angle 19 - 30 mm
9.6 Assembly: Fine adjustment of door upright angle 31 - 50 mm
9.7 Assembly: Positioning the stop shock absorber
9.8 Assembly: Door height adjustment
9.9 Assembly: Door gap fine adjustment
9.10 Assembly: Front depth fine adjustment
9.11 Assembly: Keeping the door open
10.1 Disassembling: Door closing system for stationary external face
Page
6
7
7
8
10
11
12
13
14
15
16
17
18
19
20
21
23
24
26
27
28
29
31
32
33
34
35
38
41
43
44
45
46
48
49
50
51
52