Sony PCWA-C300S Benutzerhandbuch Seite 18

3
4
18
Key
If data encryption (WEP) is enabled for the Access Point, enter the
encryption key (WEP key) here. Because this key functions as a
password that enables communication with the network, the key
entered here must be exactly the same as that set for the Access
Point. Only computers for which the key has been configured
correctly can join the network. The number of characters depends
on the "ASCII/Hex" and "Length" settings (see table below).
Permissible characters
Maximum number
of characters
Confirm key
Re-enter the encryption key that you entered in the "Key" box.
Hint
This product supports a function called "roaming" which allows the creation of a
wireless network with multiple Access Points for wider coverage. When using
this function, configure all Access Points to the same Network Name (SSID) and
Data Encryption (WEP) settings.
When you are done, click "Next".
The following screen appears.
Make sure that the settings are correct, and then click
"Connect".
Wait until the Wireless LAN PC Card connects to the Access Point.
When the Wireless LAN PC Card establishes the connection with the
Access Point, a message appears explaining that the computer is
connected to the office.
This completes the Access Point connection settings procedure.
Hint
You can change the connection settings and network connection mode from
Wireless Panel. For details about how to use Wireless Panel, refer to the Wireless
Panel Help.
ASCII
Alphanumeric characters
5 or 13 characters
Hexadecimal
0 to 9, A to F, a to f
10 or 26 characters