Programming Of Lm Og-Am And Lm Og-Taerm Series - Badger Meter LM OG-PK Montage- Und Bedienungsanleitung

Programming of LM OG-AM and LM OG-TAERM series

Programming of LM OG-AM and LM OG-TAERM series
LM OG-A (CND)
The units of measure and the correction factor can be configured in the programming
mode. A program button on the backside of the register will enable the mode, only
accessible when the register has been removed from the meter. Removing the register
from the meter will break the sealing. This seal has to be restamped by the national
authorities (MID).
01
Turn on the register by
pressing the TOTAL button.
02
By pressing the programming
button on the backside of the
register you will enter the
programming mode.
03
The measuring unit will flash
and can be changed by
pressing the RESET button
(L, GAL, QT, PT).
To move forward press the
TOTAL button.
03
Press "TOTAL" to change the
k-factor. The number to be
changed is flashing and can
be modified with "RESET".
To change the next number,
press "TOTAL"
04
The second number can now
be changed.
To move to the next number,
press "TOTAL" again.
05
The third number can now be
changed.
To move to the next number,
press "TOTAL" again.
06
The fourth number can now
be changed.
To move to the next number,
press "TOTAL" again.
LM_OG_BA_98_1803
Page 16/27
07
The fifth number can now be
changed.
To move forward, press
"TOTAL" again.
08
The arrow for the flow direction
flashes now. Use RESET to
change or TOTAL to move
forward.
09
By pressing the programming
button on the backside of the
register you will quit the
programming mode.
10
The register went into the
sleep mode.
11
To wake up the register, press
the RESET button.
12
Press „RESET" for 3 seconds
and the register displays the
checksum and serial number
in the bottom line.