Programmation Of Lm Og (Cnd) And Lm Og-Hf (Cnd) - Badger Meter LM OG Montage- Und Bedienungsanleitung

Programmation of LM OG (CND) and LM OG-HF (CND)

5. Programmation of LM OG (CND) and LM OG-HF (CND)
Measuring unit
„Total" resettable
„Total" not resettable
Press „Total" one time to
switch on the meter.
Press 3 times „Total" and
3 times „Reset" to access
the programmation mode.
Measuring unit "L" (liter) is
flashing and can be
changed in L, GAL, QT or
PT when pressing "Reset".
Press "Total" to confirm
the new measuring unit.
Press "Total" one time
to change the k-factor.
The figure to be
changed is flashing
and can be modified
with "Reset".
To change the next
figure, press "Total".
The second figure can
now be chanced.
To access the next figure,
press "Total".
The third figure can now
be chanced.
To access the next figure,
press "Total".
LM_OG_BA_98_1105
Page 12/28
The fourth figure can now
be chanced.
To access the next figure,
press "Total".
The fifth figure can now
be changed.
Press both buttons
simultaneously to save the
programmation.
The meter then goes to the
sleeping mode.
Sleeping mode
After the sleeping mode,
please press „Total" to
show the „normal"
display mode.
Press „Reset" during 3
seconds and the
register displays the
check sum.