Herunterladen Inhalt Inhalt Diese Seite drucken

Bosch GWS 24-300 PROFESSIONAL Bedienungsanleitung Seite 15

Trennschleifer
Vorschau ausblenden Andere Handbücher für GWS 24-300 PROFESSIONAL:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
1 609 929 355.book Seite 4 Dienstag, 23. März 2004 12:51 12
Test run!
Check the grinding tool before use. The
grinding tool must be properly mounted
and rotate freely. Perform a test run of at
least 30 seconds without load. Do not use
damaged, out-of-round or vibrating grind-
ing tools.
Reduced Starting Current
(GWS 24-300 J)
As a result of soft starting, a 13 A fuse is
adequate.
A machine without reduced starting current
requires higher fuse protection (use at least
a 13 A time-delay fuse).
Operating Instructions
Clamp the workpiece if it does not remain
stationary due to its own weight.
Do not strain the machine so heavily that it
comes to a standstill.
Grinding and cutting discs become very
hot while working; do not touch until they
have cooled.
Cutting
When cutting, do not press, tilt or
oscillate the machine. Work with
moderate feed, adapted to the ma-
terial being machined.
Do not reduce the speed of running
down cutting discs by applying
sideward pressure.
15 • 1 609 929 355 • TMS • 15.03.04
Cut Off Grinder Stand
With the cut off grinder stand 19 (accessory),
workpieces can be cut at angles of 0 to 45° at the
same lengths.
The stand of the cut off grinder may only be used
for cutting discs with a maximum diameter of
230 mm.
The safety notes and operating instructions in the
respective instruction manual of the cut off
grinder stand are to be strictly observed. Use only
original Bosch cut off grinder stands.
Cutting Stone (see figure
The
direction
in
which the cutting is
performed is impor-
tant.
The machine must
always work in an
up-grinding
motion.
Operate the machine with dust extraction only. In
Therefore,
never
addition, wear a dust mask.
move the machine in
the other direction!
Otherwise, the dan-
ger exists of it being
pushed
uncon-
trolled out of the cut.
English - 4
The machine must be used only for dry
cutting/grinding.
It is best to use a dia-
mond cutting disc.
For
against tilting, use
the special protec-
tive cover with cut-
ting guide 17.
19
)
A
protection

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gws 24-300 j professional

Inhaltsverzeichnis