Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING:
WARNING:
WARNING:
WARNING:
• Always switch off and disconnect the appliance
from the power supply before cleaning and user
maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
Risk of electric shock!
Risk of electric shock!
Risk of electric shock!
the plastic parts.
• The appliance must be dry before restarting oper-
ation.
CAUTION:
CAUTION:
CAUTION:
CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior
Cleaning the appliance including interior
Cleaning the appliance including interior
Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces
and the door seal regularly with warm water and
mild detergent.
• Remove for that the appliance content and stor-
age at a cool location.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting
Defrosting
Defrosting
Defrosting
CAUTION
CAUTION: : : :
CAUTION
CAUTION
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
To achieve better cooling and to save energy, defrost
the appliance regularly as follows:
• To start the defrosting process, disconnect the
appliance from the power supply.
• Remove the food items and keep covered at a
cool location.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
Cleaning
Cleaning
Cleaning
Cleaning
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Before you contact an authorized specialist st st st
Before you contact an authorized speciali
Before you contact an authorized speciali
Before you contact an authorized speciali
Problem
Problem
Problem
Problem
Cause / Action
Cause / Action
Cause / Action
Cause / Action
Appliance is
- Insert the power plug correctly or check
not working
the fuse.
or not
- Check the temperature setting.
properly
- Check the ambient temperature.
- Unblock the ventilation openings, install
the appliance freely.
Stored food
- Check the temperature setting.
is too warm
- Open the door only as long as neces-
sary.
- Check the location.
Loud noise
- Check the appliance position.
during oper-
- See the section "Operating noise".
ation
Water on the
On days of high humidity, condensation
outer sur-
might occur on the outer surface of the
face.
appliance. This is no malfunction!
NOTE:
NOTE:
NOTE:
NOTE:
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.
Technical Data
Technical Data
Technical Data
Technical Data
Electrical connec c c c tion...........................
Electrical conne
tion............................................
Electrical conne
Electrical conne
tion...........................
tion...........................
Mains voltage: ........................................220-240 V~
Mains frequency: ...........................................50 Hz
Power consumption: ........................................80 W
Dimension H x W x D / Weight...............................
Dimension H x W x D / Weight...............................
Dimension H x W x D / Weight...............................
Dimension H x W x D / Weight...............................
Appliance size: ........................144.0 x 55.4 x 55.1 cm
Net weight: ......................................approx. 47.0 kg
The right to make technical and design modifications
in the course of continuous product development
remains reserved.
20
.................
.................
.................
Werbung
Inhaltsverzeichnis
Fehlerbehebung
