BOMANN GS 3181 Bedienungsanleitung Seite 17

Assembling the door handle Assembling the door ha
Assembling the door ha Assembling the door ha
Remove the cover caps from the door outer side and
tighten the handle with the delivered screws into the
underlying holes. Put the included screw covers on.
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION CAUTION: : : :
CAUTION CAUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door o Reverse the door opening pening
Reverse the Reverse the door o door o pening pening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply. Always un-
plug the appliance first.
ndle
ndle ndle
electric
electric electric
NOTE: : : : NOTE
NOTE NOTE
• When installing, ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the cover caps on
the top cover. Loosen the
screws underneath and re-
move the top cover.
• Transfer the blind cap of the
appliance cover at the oppo-
site side.
• Dismount the upper door
hinge. Open the appliance
door a little and lift it out of the lower door hinge.
• Remove the dummy cap (B)
and insert supplied dummy
cap (A). Place the appliance door safely aside.
NOTE: : : : NOTE
NOTE NOTE
Keep the dummy cap (B) for another possible
door opening reverse.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet.
Dismount the foot bracket
and the lower door hinge.
• Attach the door hinge at the other appliance side,
after you have unscrewed the
hinge pin and used it from the
other hinge side. Transfer and fix the foot bracket
too. Turn in the feet accordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Transfer the upper door hinge at the opposite
side, after you have unscrewed the hinge pin and
used it from the other hinge side.
Put the hinge pin in the hole of
the appliance door and fasten the hinge.
17
screw wrench, Phillips screw-