Transport And Packaging; Appliance Equipment; Installation - BOMANN GS 3181 Bedienungsanleitung

Tran Transport sport and Packaging
Tran Tran sport sport
Transport the appliance Transport the appliance Transport the appliance Transport the appliance
Transport the appliance, if possible, only in vertical
position. Otherwise, it is absolutely necessary to
allow the appliance standing upright for a few hours
before installation "Prior to first use". Protect the ap-
pliance during transport against weather influences.
NOTE NOTE NOTE: : : : NOTE
The appliance has castors which facilitate the
transport and installation of the appliance. Tilt the
appliance back slightly and move it gently.
Unpack the appliance Unpack the appliance
Unpack the appliance Unpack the appliance
• Remove the appliance from its packaging.
• Remove all packaging material, such as foils, filler
and cardboard packaging.
• To prevent hazards, check the appliance for any
transport damage.
• In case of damage, do not put the appliance into
operation. Contact your distributor.
CAUTION: Transport protection! CAU CAU CAU TION: Transport protection! TION: Transport protection! TION: Transport protection!
Pull off the foil from the appliance sides.
NOTE: : : : NOTE
NOTE NOTE
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter "Cleaning".

Appliance Equipment

Appliance
Appliance Appliance
Appliance overview Appliance overview
Appliance overview Appliance overview
and Packaging
and Packaging and Packaging
Equipment
Equipment Equipment
1 1 1 1 Temperature control
2 2 2 2 Compartment with
freezing flap
3 3 3 3 Freezing drawers
4 4 4 4 Adjustable feet at the
front / castors at the
rear
Delivery sc ope Delivery sc ope
Delivery sc ope Delivery sc ope
1 x freezing flap, 4 x freezing drawer, 1 x ice-cube
tray, for assembling the door handle: door handle
incl. fixing screws with covers, for reversing the door
opening: dummy cap (A)
Conditions for the installation location Condition Condition Condition s for the installation location s for the installation location s for the installation location
• Good ventilation is required around the appliance,
in order to dissipate the heat properly and to
guarantee efficient cooling operation at low power
consumption. Sufficient clearance is necessary.
Gap to the back and to the side walls each
-
approx. 5 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter "Technical Data" or to the rating label
located in the interior or on the rear side of the
appliance.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
16

Installation

Installation Installation Installation