Operation; Before Starting Operation; Start An Operation/Stop An Operation; Mode Select - Mitsubishi Electric City Multi PLFY-P Bedienungshandbuch

2. Operation

CENTRALLY CONTROLLED
CLOCK
CHECK
˚C
STAND BY
ERROR CODE
DEFROST
4 TEMP.
2
3
TIMER SET
PAR-20MAA
˚C
TEMP.
TIMER SET
B
˚C
TEMP.
2
TIMER SET
1Hr.
ON OFF
˚C
FILTER
CHECK MODE
TEST RUN
FUNCTION
NOT AVAILABLE
ON/OFF
9
FILTER
7
CHECK TEST
1 5 0 8 6
˚C
A
ON/OFF
1
FILTER
CHECK TEST
˚C
A
ON/OFF
1
FILTER
CHECK TEST
1[Time-setting] Button
Used to set the current time, starting time, and ending time.
2[Timer/continuous] Button
Used to switch between continuous operation and timer operation.
3[Selecting operation] Button
Used to switch between cooling, dry, air blowing, and heating.
4[Room temperature adjustment] Button
Setting is made in a unit of 1 °C.
Used to set the room temperature.
5[Louver] Button
Used to adjust the lateral direction of the airflow.
6[Checking/test run] Button
Used only during checking test run.
7[Filter] Button
Pressed to reset the filter sign.
8[Up/down airflow direction] Button
9[ON/OFF] Button
Once the operation has been set, you can use it repeatedly simply by
pressing the [ON/OFF] button.
0[Fan speed adjustment] Button
∗ Some models of the indoor units have no functions. (Operation of the
remote controller becomes void.)

Before starting operation

• Make sure that the power supply is turned ON before use.
• Start running after the "HO" display has disappeared (max. 2 minutes).
• In some systems, more than one indoor unit may be connected to a
single outdoor unit. When a remote controller for one indoor unit is used
to change modes at the same time as a different indoor unit is working
together with the outdoor unit, the operation underway stops, and the
new operation begins. Until the old operation is complete, the display on
the remote controller flashes to indicate that the new operation is in
"waiting" status.
Warning:
Check and confirm the power circuit before use.
2.1. ON/OFF

Start an operation/Stop an operation

1 Press [ON/OFF] button
Operation lamp lights up/off and operation starts/stops.
A Operation lamp
Caution:
Even if the operation button is pressed immediately after the opera-
tion is stopped, operation is not restarted for about 3 minutes.

2.2. Mode select

1 If the unit is off, press the ON/OFF button to turn it on.
A The ON indicator should light up.
2 Press the operation mode (
tion mode.
B
s Cooling mode
Fan mode
Heating mode
Drying mode
Automatic (cooling/heating) mode
Note:
The heating display and the automatic display does not appear in
models that operate exclusively as cooling only air-conditioner.
) button and select the opera-
3