Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Parts Names
■ When using the wireless remote controller, point it towards the receiver on the indoor unit.
■ If the remote controller is operated within approximately two minutes after power is supplied
to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
■ The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
fluorescent lights and strong light can affect the ability of the indoor unit to receive signals.
■ If the operation lamp near the receiver on the indoor unit is flashing, the unit needs to be
inspected. Consult your dealer for service.
■ Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location with
high humidity.
■ To avoid misplacing the remote controller, install the holder included with the remote
controller on a wall and be sure to always place the remote controller in the holder after use.
■ Outdoor unit
3. Operation
3.1. Description of "AUTO RESTART FUNCTION"
• This unit is equipped with the auto restart function. When the main
power is turned on, the air conditioner will start operation
automatically in the same mode as set with the remote controller
before the shutoff of main power.
• If the unit was set to off with the remote controller before the shutoff of
main power, it will remain stopped even after the main power is turned
on.
• If the unit was in the TEST RUN before the shutoff of main power, it
will start operation, at main power on, in the same mode as set with
the remote controller before the TEST RUN.
ON/OFF
①
MODE
②
CHECK
TEST RUN
SET
4
TEMP
③
FAN
AUTO STOP
⑤
VANE
AUTO START
⑥
LOUVER
h
min
RESET
CLOCK
AAA
AAA
1. Remove the top cover, insert two AAA
batteries, and then install the top cover.
2. Press the Reset button.
Power
Ref. Pipes
Indoor-Outdoor
Connection wire
Earth
3.2. Turning ON/OFF
<To Start Operation>
■ Press the ON/OFF button ①.
Note:
● When the unit is restarted, initial settings are as follows.
Mode
Temperature setting
Fan speed
Airflow up/down
<To Stop Operation>
■ Press the ON/OFF button ① again.
Note:
Even if you press the ON/OFF button immediately after shutting
down the operation is progress, the air conditioner will not start for
about three minutes. This is to prevent the internal components
from being damaged.
Battery installation/replacement
①
②
③
Top cover
Two AAA batteries
Insert the negative (–)
end of each battery
first. Install the
batteries in the correct
directions (+, –)!
Press the Reset
button with an object
that has a narrow end.
Remote Controller settings
Last operation mode
Last set temperature
Last set fan speed
COOL or DRY
Mode
HEAT
Fan
Werbung
Inhaltsverzeichnis
Fehlerbehebung
