Operation - Worx WX712 Originalbetriebsanleitung

to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed under
the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
f) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
10
Wear eye protection
Wear dust mask
Wear protective gloves.
Make sure the tool is unplugged prior
to changing accessories.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or
retailer for recycling advice.
Angle Grinder
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.
ASSEMBLY AND OPERATION
Action
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting Disc
Adjusting wheel guard
NOTE: Before any work on the
machine itself, pull the mains plug.
For work with grinding or cutting
discs, the protection guard must
be mounted.
The coded projection on the wheel
guard (10) ensures that only a guard that
fits the machine type can be mounted.
Open the clamping lever (9). Place the
wheel guard (10) with coded projection
into the coded groove on the spindle
of the machine head and rotate to the
required position (working position).
To fasten the wheel guard (10), close the
clamping lever (9).
The closed side of the wheel
guard (10) must always point to
the operator.

OPERATION

Plugging in the Power
Using On/Off Switch
Hand Grip Areas
Rough Grinding
WARNING! Never use a cutting
disc for roughing.
Cutting
Figure
See Fig. A
See Fig.
B1, B2, B3
See Fig. C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
EN