Changing The Cartridge; Playing Records; Basic Operation - Teac TN-300 Bedienungsanleitung

Changing the cartridge

To change the cartridge, first remove the headshell from
the tone arm.
o We recommend that you keep the cartridge needle
protective cap on while changing the cartridge.
Headshell Screws
Nuts
Shell leads Cartridge
1 Disconnect the shell lead terminals
from the cartridge.
2 Loosen the screws and remove the
cartridge.
3 Attach the new cartridge and tighten
the screws.
See the illustration below for the position of the
screws when attached.
2.0 ± 0.5 mm
8
4 Connect the shell lead terminals to the
cartridge.
o The signals and colors of the shell leads are
shown below.
Signal Color
Left channel + White
Left channel − Blue
Right channel + Red
Right channel − Green
5 Balance the tone arm and adjust the
stylus pressure.
Follow the procedures in "Balancing the tone arm
and adjusting the stylus pressure" on page 5.

Basic operation

Playing records

1 Press the STANDBY/ON button on the
back of the unit to turn it on.
2 Open the dust cover slowly.
V Be careful not to pinch your hand, for exam-
ple, when opening and closing the dust cover.
3 Place a record on the turntable.
When playing a 45 RPM large-hole single record,
use the included adapter.
4 Set according to the rotation speed
(RPM) of the record.
The rotation speed can be set to 33 1/3 or 45 RPM.
5 Turn the START/STOP rotation knob to
START to start the turntable.
o When the START/STOP rotation knob is set to
START, the turntable will start rotating and the
blue LED will light.
6 Move the tone arm clasp to the right to
release the tone arm.
Clasp