AGFEO AS 43 Installationsanleitung Seite 5

Removing the Module from the Packaging
Before removing the module from the packaging touch the metal of the PC/ printer socket
on the bottom of the telephone system briefly with your finger. This will discharge any
electrostatic charges to protect the sensitive electronic equipment of the telephone system.
Module Installation
- Slot the module vertically into guide rails the expansion slot with the large connection
strip facing upwards.
- Push the module as far as it will go into the slot so that the connection strip will make
contact with the motherboard.
- Stick the relevant module sticker displaying the connection diagram above the expansion
slot of the system.
Information regarding contact assignment of the installed module refer to the sticker or
installation manual AS 43, AS 45 (IdentNr. 1101332).
Closing the Cover
1. Reconnect all trunk lines disconnected previously.
2. Insert the curved hook of the lid carefully into the slots provided.
3. Turn the lid in such a way that the straight hook will fit into the designated slot.
4. Close the lid by pressing it into position until you hear a click.
System Power Up
Ensure that the lid of the telephone system is closed before operation.
Once the lid has been fitted, plug the system back to the 230 V mains socket.
GB
5