Making The Connections; Emergency Switch; Ilda Interfaces - EuroLite VLS-1600RGB 40K Bedienungsanleitung

6

MAKING THE CONNECTIONS

Establish all connections as long as the unit is switched off.

Emergency Switch

ILDA Interfaces

You can connect laser control units that generate signals as standardized by the International Laser Display
Association to the ILDA input. Matching items such as the HE laser software by EUROLITE are available as
accessory.
The ILDA output of the unit can be connected to other laser devices. The ILDA interfaces are designed as
25-pin D-sub connectors. The drawing and table below show the pin assignment.
1 X+
2 Y+
3
Intensity+
4 Locking (Interlock) A
5
R+
6 G+
7 B+
8 User-defined signal 1+
9
User-defined signal 2+
10
User-defined signal 3+
11 User-defined signal 4+
12 Return signal from the unit
13 Shutter
www.eurolite.de
Connect the optional remote emergency switch to the REMOTE jack of the
device.
If you press the switch, the laser beam is switched off immediately.
To unlock the switch and resume operation, turn the knob clockwise.
14 X-
15 Y-
16
Intensity-
17 Locking (Interlock) B
18
R-
19 G-
20 B-
21 User-defined signal 1-
22
User-defined signal 2-
23
User-defined signal 3-
24 User-defined signal 4-
25 Ground
36