Electrolux EK276BN Benutzerinformation Seite 16

16 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the Fast‐
Freeze,FastCool or after
changing the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig‐
erator.
Water flows on the floor.
Temperature cannot be
set.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The FastFreeze function is
switched on.
The FastCool function is
switched on.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
The appliance is in demon‐
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
Solution
Refer to "FastFreeze func‐
tion".
Refer to "FastCool func‐
tion".
The compressor starts af‐
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Switch off FastFreeze
manually, or wait until the
function resets automati‐
cally to set the tempera‐
ture. Refer to "FastFreeze
function"
Switch off FastCool man‐
ually, or wait until the func‐
tion resets automatically to
set the temperature. Refer
to "FastCool function".
Keep the OK button press‐
ed for approximately 10
seconds until a long sound
is heard and display shuts
off for a short time.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".