ECG IV 29 Bedienungsanleitung Seite 36

other (there is a gap or burned food between them). In contrast, the induction heating warms the bottom of
the pot much faster, and the cooking is then faster as well, using substantially less electrical power.
Suitable cookware for cooking on an induction hob
Before use, make sure that the pot you would use is made of magentisable conductive material (enamel, cast
iron, stainless steel) while the bottom of the pot is fl at and even and has at least 12 cm diameter.
The induction hob is ready for cooking nearly immediately. Never place empty pots/pans on the ceramic
glass cootop. Place the pot/pan always at the center of the induction zone, otherwise the lower part of the
pan is heated unevenly and the food in the pan may burn.
Unsuitable cookware: ceramic, glass, aluminum, pans/pots with rounded/convex bottom or with a diameter
less than 12 cm or greater than 30 cm.
OPERATING INSTRUCTIONS
Place the induction hob on a fl at surface in such a way that the openings for air intake and outfl ow are not
covered. The distance between the wall and the induction hob must be at least 10 cm.
Small hotplate
1) Switching on
1. After plugging the induction hob in the electric outlet you will hear a beep and you will see "OFF" on
the display.
2. Press the on/off button and the display shows „ON" (on), the fan starts and the induction hob switches
from standby mode to heating mode.
3. The induction hob detects if you are using correct cookware. If yes, after the "ON" indicator shows on the
display, press the "Menu" button and you can select the cooking setting, the hob will switch on.
4. Otherwise, it is not possible to select the cooking setting after pressing the "Menu button". You will
hear repeated sound signal and the display shows warning notice E0. The induction hob will switch to
standby mode after 40 seconds.
2) Setting the power level
1. Press the "Menu" button and the light indicator of power "P" turns on.
2. After switching on, the power level is automatically set to 1300 W.
3. Set the desired power using the control knob in range 200 – 1300 W (10-stage settings altogether).
3) Setting the temperature
1. Press the "Menu" button twice and the light indicator of temperature "°C" turns on.
2. After switching on, the temperature is automatically set to 240 °C.
3. Using the control button, set the temperature to required level in the range of 60–240 °C (10 stage
temperature control).
4) Setting the timer
– when the power level is set
1. Press the "Menu" button the third time, the power level indicator will light up and the timer control; the
display will show "0:00".
2. Using the control button set the required time in the range of 0:01 – 3:00. The setting advances by 1
EN
minute.
3. After setting the timer wait, until the display shows the preset power setting 1300 W. Then using the
control button set the required power level.
– when the temperature is set
1. Press the "Menu" button the fourth time, the temperature level indicator will light up and the timer
control: the display will show "0:00".
36
IV 29 6j.indb 36 8.3.2012 17:35:51