Unox LineMiss Bedienungsanweisung Seite 9

ENGLISH
HUMIDITY set up
To set the percentage of humidity desired inside the
cavità it is sufficient to operate on the + and – keys
(percentage of humidity can be set from 0 to 100%
- 5 levels of humidity).
STEP key
The STEP key allows you to select the desired
cooking step.
Start / Stop cooking cycle
It is possibile to start the cooking cycle pressing the
START / STOP key (the related LED will switch on).
It is possibile to stop the cooking cycle pressing the
START / STOP key.
At the end of a cooking cycle the heating elements
and motors will be switched off, the buzzer will ring
for 15 seconds, the digits 0.00 will flash for 45
seconds on the display, the set temperature remains
the one entered at the beginning of the cooking
cycle and the START/STOP LED will remain turned
on.
If during the 45 seconds of flashing digits (0.00) the
operator set a time (using the + or – keys), the oven
automatically starts functioning.
At the end of the 45 seconds or if the cooking cycle
is interrupted by pressing the START / STOP keys,
all the parameters previously set will turn into 0 (the
operator will be in the same situation there is when
the oven has just been turned on) and the START/
STOP LED will be switched off.
Visualization and modification of the
cooking parameters during the functioning
of the oven
While the oven is working, it is possibile to visualize
the parameters and modify them if the oven is
working in the manual mode; to scroll the different
parameters (time, temperature, humidity) you have
to push the SELECT key. To scroll the the different
cooking steps, you have to keep pressed the STEP
key.
If you select time, the display visualizes the remaining
time (COUNTDOWN related to the selected step).
If you select temperature, the display alternately
visualizes for 4 seconds the set tempeture (fixed LED
UNO X
– it is possibile to modify the temperature using +
or – keys) and the measured temperature (flashing
LED).
If you select humidity, the display visualizes the
set percentage of humidity (related to the selected
step).
PROGRAMMED MODE
There are 70 programs available. Each program
can be composed of 1, 2 or 3 cooking steps.
Memorization of a new program
To memorize a cooking program it is necessary to
proceed as follows:
- enter the programming mode pushing the P
key: on the display you will read the writing
P01
- select the number of program you desire by
using the + or - keys (the program number
will show on the display)
- press the SELECT key
- set the cooking parameters as explained in
the manual mode
- save the program by pressing the MEM key
for 5 seconds; the storage of the program
will be confirmed by the sound of the buzzer
and by the visualization of the chosen
program number on the display
- press the P key to go back to the manual
mode,
Recall of a memorized program
To recall a memorized program it is necessary to
proceed as follows:
- enter the programming mode pushing the P
key: on the display you will read the writing
P01
- select the number of program you desire by
using the + or - keys (the program number
will show on the display)
- start the cooking program pressing the key
START/STOP
While the oven works with a program the
visualization of the cooking parameters is like the
one you have in the manual mode.
While the oven works with a program IT IS NOT
POSSIBLE to modify the cooking parameters.
It is possible to interrupt the cooking cycle by
pressing the START / STOP key.
At the end of a cooking cycle the heating elements
and motors will be switched off, the buzzer will ring
for 15 seconds, the digits 0.00 will flash for 45
seconds on the display, the set temperature remains
the one entered at the beginning of the cooking
R
ENGLISH
9