Instructions For The Installer; Data Plate; Certification; Installation - Preliminary Operations - Unox LineMiss Bedienungsanweisung

ENGLISH
I. INSTRUCTION FOR THE
INSTALLER
Dear Customer, we would like to thank you and
congratulate you on the purchase of one of UNOX
products. The instructions and suggestions that
follow concern the phases of a proper installation,
as well as the use and maintenance for your safety
and for the best use of the appliance.
1.

DATA PLATE

MODELE DU FOUR
UNOX S.p.A.
Via dell'Artigianato, 28/30
35010 - Vigodarzere (PD) - ITALY
MOD.: XF198
S/N: 00000
PROD: gg/mm/aaaa
TYPE: kW:
0000000000000
PUISSANCE ELECTRONIC
SERIE
2.

CERTIFICATION

The "CE" brand you find on our labels and on our user
manual refers to the following directives:
ELECTRIC CONVECTION OVENS - SERIES XF:
- Low Tension Directive
DBT 73/23/CEE e 93/68/CEE,
according to rule EN60335-2-42+A1 and
according to rule EN60335-2-46+A1
- Electromagnetic Compatibility Directive,
according to rules EN6555-3, EN55014,
EN55104 and EN50366(2003).
3. INSTALLATION
- PRELIMINARY OPERATIONS
All the electrical connections and installation
operations must be done by qualified personnel
accordino to actual laws.
TENSION D'ALIMENTACION
!
PATENTED
POWER: FREQUENCY:
0000000000000
CERTIFICATIONS
3.1 CHECK THE LOCATION OF INSTALLATION
Before placing the appliance, please verify the
overall measurements and the exact position of
the electrical and water connections looking at the
pictures on the attached file "TECHNICAL DATA".
3.2 FEET ASSEMBLY
You find the feet inside the appliance. The feet must
absolutely be assembled on the oven.
Do not ever use the appliance without its feet.
Assemble the feet as showed in picture:
3.3 POSITIONING
Place the appliance respecting the safety standards
in force that you find here following described.
Place the appliance so that its back and sides can
be easily reached in order to make the electrical
connections and provide the needed service.
The appliance is not suitable for built-in installation
and side by side positioning.
It is suggested to leave a distance of 10 cm.
Between the eventual wall on the back of the oven
and the chimney.
With particular reference to the ovens, all models
must be placed upon a support, for example a
prover, a stand or on the top of a table built with
non-combustible material.
Never install the appliance on the floor.
If the appliance is placed near walls, dividers, kitchen
cabinets, decorated edges, etc., it is recommended
that this be of non combustible material.
Otherwise, they must be coated with non combustible
thermal insulating material and you must be very
respectful of the fire prevention standards.
3.4 REMOVE THE PROTECTIVE FILM
UNO X
R
ENGLISH
3