Overheating Protection; Technical Data - Clatronic FR 3075 Bedienungsanleitung, Garantie

7. Please ensure that the handle of the deep fat frying basket
has been correctly attached.
• Press the ends of the wire together at the free end of the
handle.
• Insert the brackets into wire hoops inside the basket.
• The deep fat frying basket must not be more than 2/3
full. Do not overfi ll the frying basket (The maximum
fi lling quantity for chips is 200g per litre of oil/fat).
8. Rub dry humid foods with a cloth before frying.
Caution: In the case of foodstuffs which are too moist (e.g.
frozen chips etc.) large amounts of foam may form, which
under certain circumstances may cause the oil to overfl ow.
9. After use, unplug the deep fryer.
1. Make sure that the appliance is unplugged and switched off
(The control lamps are off.).
2. Take the lid off the deep fryer.
3. Remove the frying basket and fi ll the container with oil or
grease (maximum 3.3 l). The fi lling level must be located
between the minimum and the maximum level. Put the lid
back on.
Please note the following important information!
If you use fat, divide it up into small pieces and place it on
the fl oor of the deep frying vessel.
Under no circumstances should you place the fat in the
deep frying basket!
4. Insert the plug into a 230 V, 50 Hz power socket. The green
control lamp (4) lights up. Set the desired temperature by
turning the temperature control (2).
5. The red control lamp (3) lights up. Once the set temperature
has been reached the red control lamp goes off. Take the
lid off and put the frying basket with the food to be fried
carefully into the hot oil.
6. The red control lamp switches on and off several times
during frying. This is normal and it indicates that the
temperature is controlled by the thermostat and is being
maintained. At the end of the frying time (the frying time is
specifi ed on the package of the food or in the recipe) open
carefully the lid (Warning! Hot steam may be released!).
Remove the frying basket.
7. Let the oil drip from the food being fried.
8. In order to switch off the machine, please turn the tem-
perature regulator to OFF and remove the plug from the
socket.Wind the mains lead up in the form of a spiral in the
cable compartment.
Cleaning
1. Make sure that the plug is pulled out.
2. Wait until the deep fryer is completely cool before cleaning.
Wait in any case for 1 to 2 hours after use before using
again to avoid burns.
3. Unlock the frying fat vessel by pulling out the control
element upwards. Pour out the oil.
05-FR 3075 PLUS 23
Use
4. Clean the control element in the housing with a damp cloth
and household detergent if necessary. Do not immerse in
water.
5. The lid, frying basket and frying fat vessel can be cleaned in
the usual manner in soapy water or in the dishwasher.
6. Avoid using abrasive materials or sharp objects. These may
damage the deep fryer!
Changing the Odour and Fat Vapour Filter
The fi lter in the lid can be replaced. Two spare fi lters are
supplied.
• Release the screws of the cover.
• Replace the fi lter.
• Then reassemble the cover.
Tip: When these fi lters have been used up it is possible to cut
universal fi lters to size, e.g. from cooker hoods.
Troubleshooting
Device is not working
Troubleshooting:
• Check the mains connection.
• Check the position of the thermostat.
Other possible causes:
The device is fi tted with a safety switch (1).
This prevents the heater being switched on accidentally.
Troubleshooting:
Check that the control element is correctly in place.

Overheating Protection

• If you should accidentally switch on your deep fat fryer
when there is no oil or fat in it the overheating protection is
automatically turned on. The appliance is no longer ready
to be used. Unplug the deep fryer.
• Only after the device has been left to cool down completely
should the „RESTART" button (9) on the rear of the control
element be operated in order to use the deep fat fryer again.
Please use a pointed object for this purpose.

Technical Data

Model: ..............................................................................FR 3075
Power supply:............................................................230 V, 50 Hz
Power consumption:..........................................................2000 W
Protection class:........................................................................... Ι
Filling quantity: .........................................................max. 3,3 Litre
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!
23
21.04.2006, 8:06:52 Uhr