Team International EXP 7 Gebrauchsanleitung Seite 17

Fax +32 2 359 95 50

 Turn the steam control knob (1) anti-clockwise. During this operation the control light of the
steam function (4) will regularly go on and out. This means that the appliance is constantly
heating the water in order to produce steam. We therefore advice you not to start the
steaming release until the light has turned on.
 As soon as you have frothing and creamy milk, stop the steaming release by turning the
steam control knob (1) clockwise.
Caution: the steam pipe (10) should not touch the bottom of the container because it may
interfere with the steam flow.
Clean the steam pipe (10) after each use especially when it has been immersed in milk. If you
do not clean it, the inner side of the pipe can get blocked and it will be difficult to remove the
milk residues around it. The plastic nozzle of the pipe can be removed for cleaning by simply
pulling it down. In case of obstruction of the pipe, use a needle to remove the milk residues.
Just after having lathered up the milk, wipe the body of the pipe first with a damp cloth, then
keep the cloth against the steam outlet and slowly open the steam control knob (1); let the
steam escape for one or two seconds in order to throw out the milk residues and then close the
knob (1).
CAUTION: PAY ATTENTION NOT TO GET BURNED WITH THE STEAM AND THE METAL PART OF THE PIPE
PREPARING A TEA OR OTHER HOT BEVERAGES
This appliance can also just provide hot water to make tea or other hot beverages.
After having read the instructions about the first use of the appliance, put a receptacle under
the steam pipe (10) and wait for the control light of the espresso function (6) to turn on. As soon
as the control light burns (6), turn the steam control knob anticlockwise and press the pump
button (3) at the same time. Hot water will run out of the pipe.
Once you have reached the desired amount of hot water, press the pump button (3) again to
put it in the "off-position" and turn the steam control knob (1) clockwise.
CLEANING
Body of the appliance: Before cleaning the appliance turn it off, unplug it and wait until it has
cooled down. Wipe the body of the appliance with a moistened cloth. Never immerse the
appliance in water or any other liquid.
Filters: The filters can be washed in soapy water. Should coffee residues obstruct the holes, use
a small non-metallic brush to clean them.
Grid of the connection hole: The residue of ground coffee can be removed with a toothpick.
Steam pipe: See paragraph "Preparing a cappuccino".
Creamer disk: Separate the 2 components and clean them under warm water before putting
them together again.
Drip tray plate: The drip tray plate is removable and can be cleaned in soapy water.
CAUTION: NEVER TRY TO OPEN OR DISASSEMBLE THE HOUSING OF THE APPLIANCE.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
17
Assembly page 17/60
TEAM EXP 7 - 070125