Team International EXP 7 Gebrauchsanleitung Seite 15

Fax +32 2 359 95 50

 Put one or two cups under the openings of the filter holder.
 Make sure that the switches are in the OFF position.
 Now press the On/Off switch (7). The button will stay down in its "pressed" position and the
power light will burn indicating that the appliance is warming up.
 Wait until the control light of the espresso function
pump button (3). The control light of the pump will burn. The pump will switch on and after
a few seconds the coffee will flow out of the openings of the filter holder. At the beginning
you can hear that the pump will make more noise than when the water starts flowing. This
is absolutely normal.
 When the cups are filled, press the pump button again and the water will stop flowing.
 To make other espressos, empty the filter. Therefore you have to remove the filter holder
by turning it to the left. CAUTION: Be careful when you remove the filter holder (13)
because the metal parts may be hot. Never remove the filter holder (13) when the pump
button and/or the switches are turned on. Empty the filter holder above the bin. Rinse the
accessories with clear water and fill the filter again with the desired amount of coffee.
 Proceed as described here above.
Remarks:
 When using the appliance for the first time of after a long period of non-use, it is
recommended to let run through the hydraulic system at least one cup of water. Place
one cup under the steam pipe (10), turn the steam control knob anti-clockwise and press
the pump button (3). Water will come out of the steam pipe. As soon as the cup is filled,
press the pump button (3) again and turn the steam control knob (1) clockwise till the end.
Then make your espresso as described above.
 If you cannot remove the filter holder because of the pressure, let off steam by turning the
steam control knob anti-clockwise. Then try again.
Filter and filter holder for coffee pads
This filter was exclusively designed for the use of 45mm big coffee pads and has to be used in
combination with filter holder funnel for coffee pads (17) and the creamer disk (18). If you
intend to use ground coffee, you have to use the classic filter holder and the filter for ground
coffee (13 and 14) and follow the instructions below.
Attention: Unlike the classic filter holder, the filter holder for coffee pads allows you to make
only one cup of coffee at a time. For more cups you just have to repeat the following
operation.
 Put the filter holder funnel (17) into the filter holder for coffee pads (19) and make sure that
the backside of the filter holder locks into the filter holder opening.
 Put the creamer disk (18) in the filter holder funnel (17). This disk has two parts, which have
to be put together: a rubber ring and a metallic disk. As soon as they are put together, the
side of the metallic disk should be pointed downwards (in the direction of the filter holder
funnel).
 Put the filter for coffee pads (16) on the creamer disk and push until it is fixed onto the filter
holder.
 Put the coffee pad into the filter (16).
 Put the filter holder (19) into the appliance. Therefore turn the handle of the filter holder
leftwards, slide the filter holder into the connection hole (11) and turn it firmly rightwards
until it is locked in place. The filter holder (19) should be put as far as possible to the right
side of the locking zone and it should be situated at least in the middle of the appliance.
This will prevent the filter holder from loosing during the pressure increase, when the coffee
is percolating.
If the filter holder is not locked into the locking zone and if it is not at least situated in the
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
(6) burns. Wenn it is on, press the
15
Assembly page 15/60
TEAM EXP 7 - 070125