Preparing Hot Water - Jura NESPRESSO N30 Gebrauchsanweisung

To ensure that your next Nespresso will be
G
prepared at optimal temperature, reinsert the
capsule holder in the spout ring and turn it
from left to right.

Preparing Hot Water (15)

This machine equally allows you to prepare hot
water for tea or soup.
Fill the water tank with fresh water (1-4).
G
Verify that the function knob is on the «0»
G
position (10).
Turn on your machine by pressing the
G
(7).
On/Off Switch to
Once the yellow temperature control light
G
goes off, your machine is warmed up and
ready for use.
Press the steam / hot water switch to the
G
position (7).
Plunge the steam nozzle into a receptacle
G
and turn the function knob to the
on the left (15).
Once the desired quantity of water is obtai-
G
ned, return the function knob to
the «0» position.
Remove the receptacle and pivot the steam /
G
hot water nozzle over the drip tray.
Warning ! The steam / hot water nozzle
can become burning hot.
Using the steam nozzle
The steam nozzle is useful in making frothed
milk for a cappuccino, or for heating a liquid.
The water pump then works in an intermittent
cycle.
Important ! Before making steam, verify that the
capsule holder inserted in the spout ring is
empty in order to avoid that coffee becomes
encrusted and blocks the coffee spout opening.
Making milk froth for a
cappuccino (16-17)
Your machine is equipped with an integrated fro-
thing attachment specially designed to froth milk
with optimal results when making a cappuccino.
To do this :
Pour approximately 1 dl of cold whole milk
G
into a sufficiently high pot (of not more than
0.5 l maximum capacity) that can be inserted
under the steam / hot water nozzle.
First prepare a Nespresso in a cappuccino
G
cup filling it only one-third full.
Remove the capsule holder from the spout
G
ring, discard the used capsule and reinsert
the empty capsule holder in the spout ring.
position
Press the steam / hot water switch to the
G
position (16). Once the yellow temperature
control light goes off, the machine is ready
for use.
Plunge the steam nozzle into the receptacle
G
and turn the function knob to the
on the left (17). The yellow temperature
control light will go on.
Maintain the end of the nozzle under the sur-
G
face of the milk during the entire procedure
ensuring that it does not touch the base of the
receptacle.
Stop the steam by turning the function knob
G
to the «0» position. The yellow temperature
control light will go off.
Remove the receptacle and pivot the steam
G
nozzle over the drip tray.
position