Preheating Cups - Jura NESPRESSO N30 Gebrauchsanweisung

Turn the function knob again to the
G
tion on the left for just a second in order to
eliminate any residual milk that otherwise can
block the steam nozzle.
Wipe the integrated frothing attachment with
G
a clean damp cloth.
Important: To extract a Nespresso after having
used the steam, let the machine cool down. To do
this, insert the empty capsule holder into the spout
ring, place a receptacle under the coffee spout
and run the equivalent of one or two large cups of
water by turning the function knob to the
tion on the right. Return the function knob to the
«0» position. Once the yellow temperature control
light goes off, the machine is ready for use.
Heating liquids (18)
You can also heat liquids thanks to the steam /
hot water nozzle on this machine.
Verify that the function knob is on the «0»
G
position.
Turn on your machine by pressing the
G
On/Off Switch to .
Press the steam / hot water switch to the
G
position. Once the yellow temperature control
light goes off, the machine is ready for use.
Slide the tube of the frothing attachment up
G
3-5 mm.
Plunge the steam nozzle into the receptacle
G
containing the liquid to be heated and turn
the function knob to the
left (18). The yellow temperature control light
will go on.
Maintain the end of the nozzle under the sur-
G
face of the liquid during the entire procedure
ensuring that it does not touch the base of the
receptacle.
posi-
posi-
position on the
Stop the steam by turning the function knob
G
to the «0» position. The yellow temperature
control light will go off.
Remove the receptacle and pivot the steam
G
nozzle over the drip tray.
Wipe the steam / hot water nozzle with a
G
clean damp cloth immediately after its use.
Important: To extract a Nespresso after having
used the steam, let the machine cool down. To
do this, insert the empty capsule holder in the
spout ring, place a receptacle under the coffee
spout and run the equivalent of one or two large
cups of water by turning the function knob to the
position on the right. . Return the function
knob to the «0» position. Once the yellow tem-
perature control light goes off, the machine is
ready for use.

Preheating Cups

It is highly recommended that you preheat the
cups with very hot water before making the first
Nespresso of the day. Subsequent cups can be
preheated by stocking them on the cup heating
plate.
To preheat cups with the steam / hot water
G
nozzle, follow the instructions given under the
section on: "Preparing Hot Water".
Cleaning (19-21)
After the extraction of each Nespresso or the
G
use of the steam / hot water nozzle, residual
water in the thermoblock is discharged into
the drip tray provoking a light hissing noise.
It is therefore necessary to remove the grill
and empty the drip tray (19) after about 20
coffees and, at same time, to clean them with
a non-abrasive, dish washing liquid.