Jura NESPRESSO N30 Gebrauchsanweisung Seite 13

We advise you not to use distilled or mineral
water.
Start Up (5-9)
When starting up your machine for the first time,
it is advisable to first rinse the water circuit :
Plug in the machine.
G
Fill the water tank (1-4).
G
Insert the empty capsule holder in the spout
G
ring by turning it from left to right. It is not
necessary to tighten with great force to
obtain a perfect seal (5).
Place a sufficiently large container under the
G
capsule holder and a second one under the
steam / hot water nozzle (6). The function
knob should be on the «0» position.
Turn on your machine by pressing the On/Off
G
Switch to (7). The steam / hot water switch
should be on the position. Both the red
function control light and the yellow tempera-
ture control light will go on (7).
Once the yellow temperature control light
G
goes off, your machine is warmed up and
ready for use.
Turn the function knob to the
G
the right and let approximately half of the
water in the tank run through (8). Return the
function knob to the «0» position.
Turn the function knob to the
G
the left and let the rest of the water in the
tank run through to rinse the steam / hot
water circuit (9). Return the function knob to
the «0» position.
Preparing a Nespresso
(10-14)
To obtain optimal coffee quality, preheat the
machine daily with the empty capsule holder
and rinse the system before making the first and
after the last Nespresso of the day. Do this by
turning the function knob to the
the right for about 5 seconds.
Fill the water tank with fresh water (1-4).
G
Insert the capsule holder in the spout ring in
G
order to preheat it (5).
Verify that the function knob is on the «0»
G
position (10).
Turn on your machine by pressing the
G
On/Off Switch to
and the yellow control light will go on.
Once the yellow temperature control light
G
goes off, your machine is warmed up and
ready for use.
Remove the capsule holder from the spout
G
ring and insert a capsule with the largest part
towards the base (11). 1 capsule = 1 cup of
Nespresso.
position on Reinsert the capsule holder in the spout ring
G
by turning it from left to right without
tightening with great force (12).
Place a preheated cup under the capsule hol-
G
position on
der (see the section on "Preheating Cups").
Turn the function knob to the
G
the right (13).
Once your Nespresso is prepared, return the
G
function knob to the «0» position. Remove the
capsule holder from the spout ring and dis-
card the used capsule (14).
position on
(10). Both the red light
position on