Settings And Displays - Bosch TCA 52 Serie Gebrauchsanleitung

en
4 Coffee dispensing button
(strong coffee)
This button is used to dispense strong
coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
5 Steam generation button
h
The steam button generates steam for
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
g
turning the dial to or
steam, the steam generation button
foaming milk").
7 LED display
The various LEDs indicate the following:
H
on The water tank is empty and
I
on Trays full:
Empty and replace them
I
Reinsert them
S
on Run the service programme
(see "Service programme")
S
operation
J
J
on Turn dial to "O"

Settings and displays

Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4.
You can check the water hardness by
asking your local water supplier.
K
h
h
. To dispense
h
g h
/
Degree Water hardness
German (°dH) French (°fH)
1 1-7
2 8-15
3 16-23
4 24-30
least 5 seconds. The number of LEDs 7a
H I S J
, b , c , d that light up indicates
the selected water hardness.
for a hardness of 3, the LEDs 7a, b and c
H I S
( , , ) light up.
eco once. The selected
this indicates that the desired setting has
been saved successfully.
461732) is used, the water hardness should
be set to 1.
Note: If no button is pressed within 90
seconds, the appliance switches to "eco"
mode without saving the new settings. In
this case, the previous water hardness
setting is retained.
mark.
under the nozzle 8.
g h
6 to /
nozzle 8, set the dial back to "O".
(see "Switching on the appliance / Filling
the system").
13
1-13
14-27
28-42
43-54
"eco" mode.
h
for at
h
repeatedly
"0,5 l"
"0,5 l")
.
TCA52 7/2009