SEVERIN TO 2058 Gebrauchsanweisung Seite 12

power. There is a severe danger of burns
in any case of contact.
∙ Always let the pizza stone cool down
completely before it is removed from the
appliance.
∙ Caution: do not place aluminium foil or
anything similar between the grill rack and
the pizza stone. Place the stone directly
onto the rack.
∙ Do not allow the power cord to touch any
hot parts of the appliance.
∙ Do not let the power cord hang free.
∙ Always switch off and remove the plug
from the wall socket
- after use, as well as
- in cases of malfunction, and
- during cleaning.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
∙ This appliance is intended for domestic or
similar applications, such as
- in shops, offi ces and other similar
working environments,
- in agricultural working environments,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
Temperature control
With the temperature control knob, the
temperature can be set to the desired level.
4-position switch settings
Upper heat
Upper heat and lower heat with hot-air
convection
Lower heat
12
Upper heat with rotating spit
The heating elements will only be switched
on after the timer is activated.
Timer
The timer can be used for selecting either a
certain cooking time (up to 120 minutes) or
continuous operation.
For continuous operation, turn the timer knob
anti-clockwise to the position
appliance off, turn the timer knob back to
position '0'.
To programme a time, turn the timer knob
clockwise to the desired value.
To set a time of less than 20 minutes, turn
the timer to a somewhat higher setting fi rst
and then slowly turn it back to the desired
time setting. After the pre-programmed time
has elapsed, an acoustic signal indicates
that the heating elements are switched off.
Indicator lamp
The indicator lamp lights up when the
appliance is switched on. It goes out once
the pre-programmed time has elapsed, or if
the switch is turned back to position 0.
Rotating spit
When using the rotating spit, only the upper
heating function is used.
∙ When the food to be cooked is put onto
the spit, make sure that it does not come
into contact with the upper or lower
heating elements; ensure suffi cient
distance.
∙ Pierce the food to be cooked on the spit,
making sure that the spit goes through
the middle. This is to ensure that the food
does not go to near the interior walls or
the heating elements. Use the holding
. To turn the