Adjusting The Signal; Adjusting The Indicator Light; Adjusting The Size; Use - Siemens TJ10100 Gebrauchsanleitung

Adjusting the connection current:
The appliance is plugged in. The shirt ironer is
off and the programme selector switch 4, Fig.
1, is set to "0". The button band is fully lifted.
Press the and the start/stop buttons in at
the same time and keep them pressed in.
Three sound signals are emitted to confirm
the operation.
The indicator lights on the appliance indicate
the connection current setting in accordance
with the following table:
Indicator light
Start/ Stop
Changing the connection current:
The connection current is set by pressing the
"Start/stop" button. Each time the button is
pressed the connection current switches over
and three sound signals are emitted as
confirmation.
When the appliance is set to 10 amps the
ironing process takes longer.
We recommend that the shirt ironer be set
to 16 amps for enhanced performance.

Adjusting the signal

Sound signals are emitted to indicate that a
specific circumstance has taken place in the
programme.
Change in the connection current setting.
End of ironing and airing cycle

Adjusting the indicator light

The light lights up when the appliance
is working.
The start/stop light and the
when the appliance is blowing air, in any
cycle.
The start/stop light flashes during the last
minute of each cycle to indicate that cold air
is being blown and that the ironing cycle is
about to come to an end.
When the appliance is on pause, the start/
stop light flashes for the 30 seconds that
this function lasts
Before using your shirt ironer
10 A 16
On On
Off On
light light up
Adjusting size
The size of the ironing dummy is based on
European shirt sizes. The size can be
adjusted between sizes 35 and 50. These
sizes coincide with American sizes XS and
4XL. In the case of blouses, sizes 36/38 to
50/52 (S to XXL) can be used.
The ironing dummy can be adapted to
different cuts (e.g. tapering, blouse cuts) by
adjusting the size. This is done by adjusting
the 3 adjustment cords 15, Fig. 2. To adjust
the size, start by adjusting the top cord. The
volume of the ironing dummy cannot be
reduced when inflated.
Attention:
Please make sure that both upper cords
that adjust the dressman to the individual
shirt sizes are never fully tightened.
To do so ensures that the internal air flow
is not interrupted and therefore assures a
perfect ironing result.
For an optimum ironing result please
always adjust all cords to the individual cut
and size of the shirt/blouse.
2 button arm straps are supplied for ironing
short-sleeved shirts, Fig. 3.

Preparing your garments

The appliance is only intended for ironing
shirts and blouses made with non-elasticated
fabric. Garments must be spin-dried prior to

ironing.

Warning!
Do not iron knitwear or garments made
with elasticated fabric! They may loose
shape.
Ironing
In order to get the best results from ironing:
Spin dry the garment at 800
revolutions/minute after washing.
Shirts and blouses can be spin-dried at
lower speeds if your washing-machine does
not have an 800 revolution/minute spin-dry
programme. Ironing will take longer.
Thick, soft material, such as brushed cotton
or denim, can be spin-dried at higher
speeds.
24

Use