Control Panel - ROBLIN Saturn Bedienungsanleitung

USE
Button Function
A Turns the suction motor on and off at the
last speed used.
B Decreases the operating speed.
C Increases the operating speed.
D Activates intensive speed from any other
E Starts the motor at a speed that allows re-
circulation of 100 m3/h for 10 minutes in
every hour; after which the motor stops.
When the filters alarm is triggered, the
alarm can be reset by pressing and holding
this button for approximately 3 seconds.
These indications are only visible when the
motor is turned off.
F Activates automatic shutdown with a 30'
delay. Suitable to complete elimination of
residual odours. It can be activated from
any position, and is deactivated by pressing
the button or turning the motor off.
G Turns the lighting system (overhead spot-
lights) on and off. If pressed and held for 2
seconds it turns the side lights (Neon
strips) on and off.
H Turns the low intensity lighting system
(overhead spotlights) on and off.
EN

Control panel

Display
Displays the speed setting
Displays HI and the spot at
speed, even with the the bottom right flashes once
motor stopped. Inten- a second.
sive speed is timed to
run for 10 minutes, af-
ter which the system
will return to the speed
that was set previously.
Suitable to deal with
the highest level of
cooking fumes.
Displays 24 and the spot at
the bottom right flashes,
while the motor is running.
When the procedure has been
completed, the
previously displayed will
turn off:
FF indicates the need to
wash the metal grease filters.
The alarm is triggered after
the Hood has been operating
for
hours.
EF indicates the need to
change the activated char-
coal filters, and also to wash
the metal grease filters. The
alarm is triggered after the
Hood has been operating for
200 actual working hours.
Alternately
working speed and the time
remaining until the hood is
turned off. The spot at the
bottom right flashes.
indication
100 actual working
displays the
A
B
C
D
E
F
G
H
2
23
3