Insert Battery - Clatronic NBE 2795 Bedienungsanleitung

5....-05-NBE 2795
Fine-steel shearing head (nose hair remover)
Precision shearing head (hair cutting machine)
Combination foot
Dressing comb
Cleaning brush
Special oil
• Open the battery compartment by turning the bottom section - see marking - to
the left.
• Insert a 1.5 V battery of type AA with the plus pole (+) facing towards the front
into the battery holder.
• Replace the lid of the battery compartment.
Switching on the nasal hair remover
1. Take the protection cap off the shearing head.
2. Push the on/off switch in the direction of the shearing head to position "1" in
order to switch the device on. Warning: Do not switch on the device with the
protection cap not mounted on the device!
3. Insert the tip of the fine-steel shearing head into your nostril. Warning: remove
only the hair coming out of your nose and do not press the device inwards! Do
not insert the shearing head too deep and forcefully into your nose: risk of
injury!
4. If pieces of hair remain in your nose after cutting, remove these simply by clea-
ning your nose.
5. Switch off the device by turning the on/off switch to position "0".
6. Take the cleaning brush and stroke it away from the centre over the fine-steel
shearing head.
7. After cleaning insert the cleaning brush back into the holder.
ATTENTION: Depending on the quantity of cut hair it is advisable to thoroughly
clean the device from time to time as described below in "Cleaning"!
Switching on the hair-cutting machine
Please change the attachments, remove the adapter with the fine-steel shearing
head and screw on the precision shearing head.
28.01.2003 11:51 Uhr
Accessories

Insert Battery

(not supplied)
Seite 27
27
GB