Important Safeguards - Team sis 1 Gebrauchsanleitung

Fax +32 2 359 95 50


IMPORTANT SAFEGUARDS

Please read these instructions carefully before using the appliance.

Always place the base of the appliance on a stable ironing board, table or on the

ground.
Check that your mains voltage corresponds to that stated on the rating plate of the

appliance.
Only connect the appliance to a mains earthed wall socket.

To avoid a circuit overload, do not operate another high wattage appliance on the same

circuit.
If an extension cord is absolutely necessary, a 10-ampere or higher cord should be used.

Never use cords rated for less than 10-ampere. Care should be taken to arrange the cord
so that it cannot be pulled or tripped over.
Never leave the appliance unsupervised when switched on and especially the steam iron

when it is heating. Keep out of reach of children or incompetent persons.
Only use the appliance for domestic purposes and in the way indicated in these

instructions.
Never immerse the appliance in water or any other liquid for any reason whatsoever.

Never place it into the dishwasher.
Never use the appliance near hot surfaces.

From time to time check the cord for damages. Never use the appliance if cord or

appliance shows any signs of damage but have it checked and repaired by a competent
qualified electrician (*). Should the cord be damaged, it must be replaced by a
competent qualified electrician
Should the cord be damaged, it must be replaced by a competent qualified service

Do not operate iron or steam tanks with a damaged power cord or supply hose or if the

iron or steam tank has been stopped or damaged. To avoid the risk of electric shock, do
not disassemble the iron or steam tank, take it to a qualified serviceman for examination
and repair. Incorrect re-assembly can cause a risk of electric shock when the iron or steam
tank is used.
Do not allow power cord and cord binding the base to the steam iron to touch hot

surfaces.
Never use the appliance outside and always place it in a dry environment.

Never use accessories that are not recommended by the producer. They could constitute

a danger to the user and risk to damage the appliance.
Never move the appliance by pulling the cord. Make sure the cord cannot get caught in

any way. Do not wind the cord around the appliance and do not bend it.
Fully unwind the mains cord and supply hose before starting to iron.

The steam tank and iron switches should always be turned to "0" before plugging or

unplugging the power cord from outlet; instead, grasp plug and pull to disconnect.
REMOVE THE MAINS PLUG FROM THE WALL SOCKET AND ALLOW THE IRON AND THE WATER

TANK TO COOL DOWN BEFORE OPENING, FILLING, EMPTYING, MOVING OR CLEANING THE
LATTER.
Always unplug the iron and place it on the stand when leaving, even when only for a short

while.
Burns can occur from touching hot metal parts, hot water, or steam.

NEVER UNSCREW THE CAP OF THE STEAM TANK WHILE THE APPLIANCE IS CONNECTED TO THE

MAINS WALL SOCKET AND ESPECIALLY WHEN STEAM IS BEING PRODUCED.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
.
(*)
10
Assembly page 10/40
special instruction from
TEAM SIS 1(S) - 060124
Team
.
(*)