Steam Ironing - Team sis 1 Gebrauchsanleitung

Fax +32 2 359 95 50

(E.g. an article consisting of "60% polyester and 40% cotton" should be ironed at the
temperature indicated for polyester and without steam).
If you do not know what kind(s) of fabric(s) the article has been made of, find a spot,
which will be invisible when wearing or using the article to try out the ironing temperature.
(Always start at a low temperature and increase to one, which gives the required results).
 Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. It is
recommended to apply shot-of-steam and use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of the fabric may occur. This can be
prevented by turning the article inside out and ironing the inside or by interposing a light
damp cloth.
 Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction
only (with the nap), applying only light pressure.
Always keep the iron moving.
Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this

may cause stains.
FILLING WITH WATER (FOR STEAM-IRONING)
 Make sure the main plug is unplugged from the wall socket.
 Switch off the iron by pressing its switch
 Switch off the steam tank by pressing its switch
dot).
 Position the base of the appliance on a stable flat surface and unscrew the cap (if you left
water in the tank and the cap screwed, a light degazing will happen during the next use.
It‟s normal and presents no danger).
 Fill the steam tank with water (max. 1 litre).
 You can use tap water, however, if the water is very hard, it is advisable to use distilled
water.
 Never use vinegar, descaling agents or other chemicals.
 Close the steam tank by turning the screw cap clockwise by hand (see page 4).
WHILE IRONING
CAUTION : WHEN THE APPLIANCE IS IN OPERATION, THE STEAM TANK WILL BE UNDER PRESSURE
WITH HOT STEAM.
FIRST OF ALL BE SURE THAT THERE IS NO MORE STEAM IN THE WATER TANK. THE BASE AND THE
IRON ARE ALWAYS UNDER PRESSURE, BLEED THE TANK BY PUSHING THE BUTTON (E) UNTIL NO
MORE STEAM ESCAPES, THEN SWITCH OFF THE BASE AND THE IRON (SWITCHES
IN OFF-POSITION). CAREFULLY UNSCREW THE CAP IN ORDER TO CHECK IF THERE IS NO MORE
STEAM AND THEN UNSCREW IT COMPLETELY. LET THE TANK A FEW MINUTES COOL DOWN AND
THE FILL IT AGAIN. ATTENTION: IF YOU FILL TOO EARLY, STEAM OR HOT WATER WILL ESCAPE FROM
THE OPENING. WE ADVISE YOU TO PROCEED SLOWLY WHEN YOU FILL IN EVEN AT THE
BEGINNING. FINALLY CLOSE THE WATER TANK WITH THE CAP. YOUR APPLIANCE IS READY TO
OPERATE.
STEAM-IRONING
 As indicated on the temperature dial (G) and the table, steam ironing is only possible at
higher ironing temperatures, so set the dial to  or .
 Fill the water tank with water and insert the mains plug into a wall socket.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
to the OFF-position (side without the dot).
to the OFF-position (side without the
12
Assembly page 12/40
special instruction from
AND
TEAM SIS 1(S) - 060124
Team