Important Safeguards - Team Venga VG SIS 1 Bedienungsanleitung

Fax +32 2 359 95 50

IMPORTANT SAFEGUARDS

Please read these instructions carefully before using the appliance, and always follow the
safety and operating instructions.
Important: People (including children) who are not able to use the appliance in a safe way,
due to their physical, sensorial or mental capacity or their lack of experience or knowledge,
must never use the appliance except if they are supervised by a person responsible for their
safety or if they previously received instructions concerning the safe use of the appliance.
Close supervision is necessary to prevent children from using the appliance as a toy.
Always place the base of the appliance on a stable ironing board, table or on the
ground.
Check that your mains voltage corresponds to that stated on the rating plate of the
appliance.
Only connect the appliance to a mains earthed wall socket.
To avoid a circuit overload, do not operate another high wattage appliance on the same
circuit.
If an extension cord is absolutely necessary, a 10-ampere or higher cord should be used.
Never use cords rated for less than 10-ampere. Care should be taken to arrange the cord
so that it cannot be pulled or tripped over.
Never leave the appliance unsupervised when switched on and especially the steam iron
when it is heating.
From time to time check the appliance for damages. Never use the appliance if cord or
appliance shows any signs of damage but have it checked and repaired by a competent
qualified service . Should the cord be damaged, it must be replaced by a competent
(*)
qualified service .
(*)
Only use the appliance for domestic purposes and in the way indicated in these
instructions.
Never immerse the iron or the base in water or any other liquid for any reason whatsoever.
Never use the appliance near hot surfaces.
Do not allow the power cord and the cord binding the base to the steam iron to touch
hot surfaces.
Never use the appliance outside and always place it in a dry environment.
Never use accessories that are not recommended by the producer. They could constitute
a danger to the user and risk to damage the appliance.
Never move the appliance by pulling the cord. Make sure the cord cannot get caught in
any way. Do not wind the cord around the appliance and do not bend it.
Always unplug the appliance when it is not in use.
Burns can occur from touching hot metal parts, hot water, or steam.
Always place the iron on the base of the appliance, on the foreseen place. Do not place
the iron on its rear cover. Be sure that it does not come in contact with flammable
materials or with the mains cord.
Never fill the water tank with vinegar, descaling agents or other chemicals.
Before using for the first time, remove any sticker or protective foil from the soleplate.
Clean the soleplate with a soft cloth.
Some parts of the iron have been slightly greased and as a result the iron might slightly
smoke when switched on for the first time. After a short while, however, this will cease.
The iron shall be used and placed on a stable level surface.
Do not use the iron if it has fallen, if it shows any visible signs of damage or if it leaks.
When you place the iron on its support (if available with the model), make sure that the
surface on which you put the support is stable.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
9
Assembly page 9/48
special instruction from
VG SIS 1 - 101213
Team