Dry Ironing - Team sis 1 Gebrauchsanleitung

Fax +32 2 359 95 50

 Set switch of the steam tank
illuminated switch goes out, it means that the water in the water tank has reached the
temperature necessary for steam-ironing.
 The iron heats up faster than the steam tank. Hence you can switch on the iron a few
minutes later than the steam tank.
 Select the required ironing temperature with the temperature dial (G).
 Set switch of the iron
on.
 After a few minutes, pilot light (F) will go out. This indicates that the soleplate has reached
the set temperature.
 Press the steam button (E) to release bursts of steam from the soleplate of the iron. Release
the button and the steam will stop. If you want a continuous jet of steam, slide the central
part of the steam button backwards till it blocks the steam button. To stop the steam, slide
the central part of the steam button forwards.
 By turning the steam regulator (H), the quantity of steam can be varied according to the
type of textile to be ironed (more or less delicate).
 During steam ironing, the pilot light (F) will come on from time to time. When this happens,
the iron is being heated-up to the required temperature. You can continue ironing.
 When you use a lot of steam in a very short time, the steam debit is lightly reduced until
your appliance produces enough steam to reduce the difference. This phenomenon also
happens when there isn‟t enough water in the water tank.
STEAMING IN A VERTICAL POSITION
You have to hang the cloth you want to smooth out avoiding the creases and place the iron in
a vertical position at a few centimetres from the piece of cloth. Then move the iron by pressing
the burst of steam button.

DRY IRONING

 For ironing without steam, do not press-in the steam button (E)
 You may switch off the steam tank by setting switch
dot)
WHEN FINISHED IRONING
 Switch off the base of the appliance and the iron.
 Remove the mains plug from the wall socket and let it cool down.
 It is not necessary to pour the remainder of water out of the steam tank.
 We recommend placing the iron on its base when you store it. The therefore foreseen
place is non-slip and won‟t damage the soleplate of the iron.
CLEANING
 The plastic parts of the appliance can be cleaned with a damp cloth.
 To clean the soleplate of the iron, you will also find specific products in the shops. Please
also read the instructions of use. Never use abrasive products to clean it.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
to the ON-position (side with a dot). When this
to the ON-position (side with dot). The pilot light (F) will come
13
Assembly page 13/40
special instruction from
to the OFF-position (side without a
TEAM SIS 1(S) - 060124
Team