Operation; Specification - Azusa MIK0110 Bedienungsanleitung

1. Connect one end of the AC/DC adapter to power mains and the other end to the receiver's DC
input.
2. Turn on the receiver with the power switch placed on the front panel of the receiver, the power
indicator will turn red.
3. Fully extent the antennas.
4. Connect this receiver to an external device (e.g amplifier) with a proper cable.
5. Make sure battery is inserted into the handheld microphone/wireless transmitter. Slide the
transmitter's/microphone's power switch to ON. Respectively, channel A/B indicator will turn
green, it means that the signal is available for the receiver from the microphone. Adjust the
volume switch on the receiver, and in case of clip-on/headset microphone adjust gain knob.
NOTES:
the device supports only up to 2 microphones simultaneously. Although the set includes
2 handheld microphones and 2 wireless transmitters for clip-on/headset microphones, the receiver
can work with 2 microphones simultaneously, each on different frequency!
Overall system
• Channels: 2
• Frequency range: VHF 210-270 MHz
• Frequency stability: +/- 0.005%
• Modulation: FM
• Deviation: 25 kHz
• Frequency response: 40 Hz-18 kHz
• S/N ratio: > 80 dB
• Dynamic range: > 80 dB
• Dynamic distortion: < 0.5%
• Transmitting power: < 30 mW
• Range: up to 50 m
• Working temperature: -10ºC to +50ºC
• Transmitters power supply: 9 V
Receiver
• S/N ratio: > 80 dB
• Sensitivity: 60 dB S/N (12 dB u)
• Output level: 0-1 V
• Power consumption: 2 W
• Audio outputs: Jack 6,3 mm (mixed), balanced XLR (mixed)
• AC/DC adapter:
• input: 220-240 V AC; 50/60 Hz
• output: 12 V DC; 250 mA
Owner's manual

OPERATION

SPECIFICATION

EN
9