Azusa MIK0110 Bedienungsanleitung Seite 8

RECEIVER (back)
7. Antenna
8. DC input
9. Jack 6,3 mm mixed output
10. B alanced XLR mixed output
TRANSMITTER (top)
11. Gain adjust knob (adjustment of the
microphone's sensitivity)
12. T ransmitter's power switch (ON /
Standby: the microphone is ON, but
without audible sound / OFF)
13. C lip-on/headset microphone input socket
MICROPHONE
14. H andheld microphone power switch (ON / Standby: the microphone is ON, but without audible
sound / OFF)
15. B attery compartment
16. S crew top
EN
MICROPHONE/TRANSMITTER BATTERY REPlACEMENT
Handheld microphone:
Twist the screw top anti-clockwise and remove the top. Insert 9 V battery into handheld microphone
(pay attention to correct polarity).
Wireless transmitter:
Slide the front cover of the transmitter upwards. Insert 9 V battery into the transmitter (pay attention
to correct polarity).
Note: If the signal from the microphone is off or dusky, the battery is flat; replace the battery.
8
Owner's manual