Technical Data; Introduction; Safety Regulations - Diamond3 3510 Bedienungsanleitung

GB
CONTENTS
1. Technical data.................................... 16
2. Introduction ....................................... 16
3. Safety regulations ............................... 16
4. Electricity and safety............................ 17
5. Characteristics.................................... 17
6. Unpacking and set up......................... 18
7. Various sawing processes .................... 20
8. Safety ................................................ 20
9. Maintenance...................................... 21
10. Declaration of Conformity ................... 21
11. Spare parts ........................................ 22

1.TECHNICAL DATA

Type ..................... Diamond³ 3510 / 3515 RS
Power ..........................................115V/50Hz
Capacity.............................................3,0 HP
Blade diameter/hole .............. Ø350/25,4 mm
Max. saw height ............................... 105 mm
Saw spindle speed ........................ 2.800 RPM
Sawing length ................... 1.000 / 1.500 mm
Table dimensions......1.000 / 1.500 x 640 mm
Length .............................. 1.650 / 2.150 mm
Width .............................................. 650 mm
Height (without legs) ......................... 780 mm
Weight...................................... 118 / 136 kg
Noise level...................................... 87 dB (A)
Noise level during sawing ................ 96 dB (A)
Carefully read the Instruction Manual
and the
connecting the machine to the power
supply and start using it.
OPERATING MANUAL
Safety Instructions before

2.INTRODUCTION

This sawing machine is designed and intended
for the professional contractor. The machine is
equipped with a height adjustable saw head
which moves horizontally along a guiding
beam. The material to be cut is positioned on
the saw table. The saw must be fed through the
material. Through continuous supply of cooling
water the cutting quality is improved as well as
the wear on the saw blade is minimized. The
cooling water also absorbs the saw dust.
The quality and construction of this sawing
machine meet the highest standards. The
design is based on longevity and minimal
maintenance.

3.SAFETY REGULATIONS

1. The sawing machine is only to be used for
sawing tiles, concrete products and natural
stone.
2. Only saw blades advised by the manufactu-
rer should be used.
3. Check the following before you start sawing:
The machine should be positioned on a sta-
ble, flat and horizontal base.
The saw blade must be correctly mounted.
(direction of rotation and centred correctly)
The condition of the saw blade.
Correct fixing of the saw cover.
Sufficient supply of clean cooling water.
4. During sawing the material to be cut should
not be tilted or moved.
16